Electrical discharge machining (EDM) is a modern technology that is widely used in the
production of difficult to cut conductive materials. The basic problem of EDM is the stochastic …

The paper is a critical review of existing methods that permit in situ measurement of large
external cylindrical surfaces. Large size cylindrical elements are used in many industries, eg …

This paper proposes a novel origami-inspired cube pipe structure driven by magnetic force,
and investigates its deformation and trigger force using experimental and numerical …

In the paper, the fabrication method and characteristics of porous coatings on Ti-Nb-Zr-Sn
alloy biomaterial obtained by plasma electrolytic oxidation (PEO) are presented. The PEO …

In this paper, a preparation method and characteristics of porous coatings enriched in
copper distributed in the whole volume on a ternary Ti-Nb-Zr alloy biomaterial obtained by …

The paper solves the problem of the nonexistence of a new method for calculation of
dynamics of stress-deformation states of deformation tool-material systems including the …

In this study, surface characteristics of the samples of experimentally manufactured
woodplastic composites (WPC) were determined. Turning process was used to produce …

The aim of the paper was to examine the influence of cutting conditions on the roughness of
surfaces machined by longitudinal turning, namely of surfaces coated with Stellite 6 …

The aim of the paper is to study and determine the effect of voltage increasing from 500 up to
650 VDC on chemical and electrochemical properties of the obtained porous coatings with …

Researchers and industry professionals often use surface metrology techniques to analyze
and quantify these surface characteristics, enabling them to make informed decisions about …