[HTML][HTML] Application of the photoacoustic approach in the characterization of nanostructured materials
A new generation of sensors can be engineered based on the sensing of several markers to
satisfy the conditions of the multimodal detection principle. From this point of view …
satisfy the conditions of the multimodal detection principle. From this point of view …
Temperature profile and thermal piston component of photoacoustic response calculated by the fractional dual-phase-lag heat conduction theory
We present the temperature distribution predictions for photothermal systems by considering
an extension of dual-phase lag. It is an extension of the GCE-II and GCE-III models with a …
an extension of dual-phase lag. It is an extension of the GCE-II and GCE-III models with a …
Estimation of linear expansion coefficient and thermal diffusivity by photoacoustic numerical self-consistent procedure
MV Nesic, MN Popovic, SP Galovic… - Journal of Applied …, 2022 - pubs.aip.org
In this paper, a self-consistent inverse procedure is developed for the estimation of linear
thermal expansion coefficient and thermal diffusivity of solids from transmission …
thermal expansion coefficient and thermal diffusivity of solids from transmission …
Thermal properties study of silicon nanostructures by photoacoustic techniques
K Dubyk, T Nychyporuk, V Lysenko… - Journal of Applied …, 2020 - pubs.aip.org
The photoacoustic method with piezoelectric detection for the simultaneous evaluation of the
thermophysical properties is proposed. The approach is based on the settling of an …
thermophysical properties is proposed. The approach is based on the settling of an …
Photoacoustic measurements of the thermal and elastic properties of n-type silicon using neural networks
КL Djordjevic, DD Markushev, ŽМ Ćojbašić… - Silicon, 2020 - Springer
In this paper, a simple multilayer perceptron neural network with forward signal propagation
was designed and used to simultaneously determine the main physical parameters, such as …
was designed and used to simultaneously determine the main physical parameters, such as …
Photothermally induced temperature variations in a low-absorption sample via backside absorption
VV Miletic, MN Popovic, SP Galovic… - Journal of Applied …, 2023 - pubs.aip.org
In order to make the photothermal effect detectable from a sample with low optical
absorption, an optically opaque layer must be applied on its surface. A model of optically …
absorption, an optically opaque layer must be applied on its surface. A model of optically …
Estimation of thermal properties using only one surface by means of infrared thermography
In this work was used infrared imagery to estimate thermal properties of solid materials. The
Two Superficial Hot Points Technique (TSHP) was proposed and it uses heat flux and …
Two Superficial Hot Points Technique (TSHP) was proposed and it uses heat flux and …
[HTML][HTML] Developing the techniques for solving the inverse problem in photoacoustics
In this work, theoretically/mathematically simulated models are derived for the photoacoustic
(PA) frequency response of both volume and surface optically-absorbing samples in a …
(PA) frequency response of both volume and surface optically-absorbing samples in a …
Time-resolved photoacoustic response of thin solids measured using minimal volume cell
The photoacoustic effect was explained more than half a century ago and has since been
used to develop non-destructive and non-contact techniques for testing materials. Most …
used to develop non-destructive and non-contact techniques for testing materials. Most …
Contact heat transfer analysis between mechanical surfaces based on reverse engineering and FEM
L Zhang, J Yuan, S He, S Huang, S Xiong, T Shi… - Tribology …, 2021 - Elsevier
In engineering application, analyzing the temperature field of structures is often necessary.
The contact surface is constituted by the superposition of different scales of rough surfaces …
The contact surface is constituted by the superposition of different scales of rough surfaces …