Heat transfer—A review of 2003 literature

RJ Goldstein, WE Ibele, SV Patankar, TW Simon… - International Journal of …, 2006 - Elsevier
The present paper is intended to encompass the English language heat transfer papers
published in 2003, including some translations of foreign language papers. This survey …

CFD based performance analysis of a solar air heater duct provided with artificial roughness

S Kumar, RP Saini - Renewable energy, 2009 - Elsevier
In the present work the performance of a solar air heater duct provided with artificial
roughness in the form of thin circular wire in arc shaped geometry has been analysed using …

Effect of rib spacing on heat transfer and friction in a rectangular channel with 45 angled rib turbulators on one/two walls

G Tanda - International Journal of Heat and Mass Transfer, 2011 - Elsevier
An experimental investigation of forced convection heat transfer in a rectangular channel
(aspect ratio AR= 5) with angled rib turbulators, inclined at 45°, is presented. The angled ribs …

[图书][B] Modelling of convective heat and mass transfer in rotating flows

IV Shevchuk - 2016 - Springer
This monograph was conceived as an overview of the potential and achievements of the
analytical and numerical modelling of convective heat and mass transfer in different types of …

Heat transfer in solar receiver heat exchanger with combined punched-V-ribs and chamfer-V-grooves

P Promvonge, S Skullong - International Journal of Heat and Mass Transfer, 2019 - Elsevier
An experimental work has been carried out to investigate the influence of combined
turbulence promoters (or turbulators) on forced convection and fluid flow resistance …

[HTML][HTML] Thermal-hydraulic performance of solar receiver duct with inclined punched-ribs and grooves

N Jayranaiwachira, P Promvonge, C Thianpong… - Case Studies in Thermal …, 2022 - Elsevier
The article presents an experimental study on turbulent airflow friction and thermal
behaviors in a solar receiver heat exchanger duct mounted with combined inclined …

Experimental validation of large eddy simulations of flow and heat transfer in a stationary ribbed duct

EA Sewall, DK Tafti, AB Graham, KA Thole - … journal of heat and fluid flow, 2006 - Elsevier
Accurate prediction of ribbed duct flow and heat transfer is of importance to the gas turbine
industry. The present study comprehensively validates the use of large eddy simulations …

On flow structure, heat transfer and pressure drop in varying aspect ratio two-pass rectangular channel with ribs at 45

W Siddique, IV Shevchuk, L El-Gabry… - Heat and Mass …, 2013 - Springer
To increase the thermal efficiency of gas turbines, inlet temperature of gas is increased. This
results in the requirement of cooling of gas turbine blades and vanes. Internal cooling of gas …

Numerical predictions of the effect of rotation on fluid flow and heat transfer in an engine-similar two-pass internal cooling channel with smooth and ribbed walls

M Schüler, HM Dreher, SO Neumann, B Weigand… - 2012 - asmedigitalcollection.asme.org
In the present study, a two-pass internal cooling channel with engine-similar cross-sections
was investigated numerically. The channel featured a trapezoidal inlet pass, a sharp 180 …

Numerical investigation of flow friction and heat transfer in a channel with various shaped ribs mounted on two opposite ribbed walls

K Wongcharee, W Changcharoen… - International Journal of …, 2011 - degruyter.com
Heat transfer and fluid flow characteristics through a channel with two-dimensional
transverse ribs are numerically investigated. The effects of different shaped ribs (rectangular …