This paper describes and illustrates a convenient, new method for checking repeatability
and reproducibility by direct comparisons of measured heights. Focus variation, confocal …

Sheet metal forming processes, the purpose of which is to give the shaped material
appropriate mechanical, dimensional and shape properties, are characterised by different …

Processes of surface texture characterisation can be roughly divided into measurement
issues and analysis of the results obtained. Both actions can be fraught with various errors …

The objectives of this study were to investigate the fracture surface topography of
X8CrNiS18-9 austenitic stainless-steel specimens for different loadings and notch radii and …

In this paper, the application of an Autocorrelation Function for the characterisation of
surface topography was validated. The roughness evaluation of turned composite surfaces …

Characterization of surface topography, roughly divided into measurement and data
analysis, can be valuable in the process of validation of the tribological performance of …

In this paper, the methods of compensation of differences in the results of entire bending-
fatigued fracture surface topographies were presented. The roughness evaluation was …

In this paper, the validity of the application of an autocorrelation function for resolving some
surface topography measurement problems was presented. Various types of surfaces were …

In this study, different fracture surfaces caused by fatigue failure were generated from
18Ni300 steel produced by selective laser melting (SLM). Hollow round bars with a …

The development of models for the coefficient of friction is difficult due to many factors
influencing its value and many tribological phenomena that accompany contact between …