[HTML][HTML] Carbon fiber reinforced metal matrix composites: Fabrication processes and properties
This paper reviews the research and development works conducted over the past few
decades on carbon fiber reinforced metal matrix composites (CFR-MMC). The structure and …
decades on carbon fiber reinforced metal matrix composites (CFR-MMC). The structure and …
Effectively enhanced load transfer by interfacial reactions in multi-walled carbon nanotube reinforced Al matrix composites
The thermal expansion response of multi-walled carbon nanotube (MWCNT) reinforced Al
matrix composites was employed to discuss the improvement of the load transfer at the …
matrix composites was employed to discuss the improvement of the load transfer at the …
Review of spark plasma sintering process
DB Kumar, KMA Jerrin, N Joseph… - IOP Conference Series …, 2020 - iopscience.iop.org
This paper reviews the spark plasma sintering process. The spark plasma sintering (SPS)
technique is a sintering technique in which the plasma is produced when the sintering is …
technique is a sintering technique in which the plasma is produced when the sintering is …
[HTML][HTML] Interfacial microstructure of graphite flake reinforced aluminum matrix composites fabricated via hot pressing
The microstructure of graphite flake (GF) reinforced aluminum (Al) matrix (Al–GF)
composites was observed in detail. Due to thermal mismatch between Al and GF, an inner …
composites was observed in detail. Due to thermal mismatch between Al and GF, an inner …
Micromechanics analysis on the microscopic damage mechanism and mechanical behavior of graphite fiber-reinforced aluminum composites under transverse …
Z Wang, Z Wang, B Xiong, C Cai, Z Xu, H Yu - Journal of Alloys and …, 2020 - Elsevier
In this paper, the transverse tensile behavior and microscopic damage evolution of graphite
fiber-reinforced aluminum composites were investigated by numerical and experimental …
fiber-reinforced aluminum composites were investigated by numerical and experimental …
Effect of SPS frequency on the transformation of diamond to graphite in WC-Co composite
Abstract (WC–6wt% Co)/5Vol% diamond composites were successfully fabricated at 1150–
1300° C and 40 MPa for 5 minutes under the thermodynamically unstable conditions of the …
1300° C and 40 MPa for 5 minutes under the thermodynamically unstable conditions of the …
Simple fabrication and characterization of discontinuous carbon fiber reinforced aluminum matrix composite for lightweight heat sink applications
H Kurita, E Feuillet, T Guillemet, JM Heintz… - Acta Metallurgica Sinica …, 2014 - Springer
The constant increase in power and heat flux densities encountered in electronic devices
fuels a rising demand for lightweight heat sink materials with suitable thermal properties. In …
fuels a rising demand for lightweight heat sink materials with suitable thermal properties. In …
Micromechanical modeling of damage evolution and mechanical behaviors of CF/Al composites under transverse and longitudinal tensile loadings
This paper investigates the progressive damage and failure behavior of unidirectional
graphite fiber-reinforced aluminum composites (CF/Al composites) under transverse and …
graphite fiber-reinforced aluminum composites (CF/Al composites) under transverse and …
Microscopic Analysis of the Surface Morphology of Multilayer Structures of the AluminumAlloy–Silicon Type after Water Jet Cutting
J Józwik, A Ruggiero, M Leleń - Manufacturing Technology, 2023 - journalmt.com
The paper presents the results of an experimental work on the assessment of microscopic
morphology of the surfaces obtained as a result of cutting with a Water Jet (WJ) water …
morphology of the surfaces obtained as a result of cutting with a Water Jet (WJ) water …
In situ aluminum matrix composites fabricated from Al–Ni2O3 system through microwave synthesis
Aluminum matrix composites reinforced with α-Al 2 O 3, Al 3 Ni and Al 3 Ni 2 particulates
were fabricated from Al and Ni 2 O 3 powders by microwave synthesis. The reaction …
were fabricated from Al and Ni 2 O 3 powders by microwave synthesis. The reaction …