Flanging is sheet metal forming process which has high-end applications from automobile
industry to aircraft industry. Straight, stretch, shrink and hole-flanging are the variations of …

Elastic recovery of the material, called springback, is one of the problems in sheet metal
forming of drawpieces, especially with a complex shape. The springback can be influenced …

Mg alloys possess an inherent plastic anisotropy owing to the selective activation of
deformation mechanisms depending on the loading condition. This characteristic results in a …

In this manuscript, we present a comprehensive overview of true digital twin applications
within the manufacturing industry, specifically delving into advancements in sheet metal …

The development of models for the coefficient of friction is difficult due to many factors
influencing its value and many tribological phenomena that accompany contact between …

Friction is one of the most important technological phenomena and has a large influence on
the flow characteristics of a deformed material. A strip drawing friction test was used to …

Springback prediction for a metal sheet during the forming process has always been a
practical problem. In this paper, based on the mixed plastic hardening rule, which …

Friction in sheet-metal-forming processes not only affects the values of the force parameters
of the process but also determines the quality of the surface of the drawpieces. This paper …

This article presents research results on the effect of sheet metal surface roughness,
lubricant conditions and sample orientation on the value of friction coefficient in the …

The present paper aimed to discuss the fracture in a symmetrical channel-shaped product
during the roll forming process using Lou–Huh ductile fracture criterion. Employing the roll …