Abstract Al–Zn–Mg–Cu alloys can be fabricated by a series of thermo-mechanical
processing methods (eg, hot rolling, forging and extrusion), which is able to serve in …

The effect of equal channel angular pressing (ECAP) and further cold upsetting (CU)
process on the kinetics of precipitation during aging of solid solution treated 7050 Al alloy …

In the present work, for the first time, the effect of asymmetric rolling at room temperature on
the microstructural evolution, texture, hardness, tensile properties, and fracture surface of …

The presence of the dizinc magnesium (MgZn2) phase in Al–Zn–Mg–Cu alloy significantly
enhances its mechanical properties due to the high density, uniform distribution, and fine …

Abstract Al-7.3 Zn-2.2 Mg-2Cu alloy is known for its high strength, achieved because of
higher alloying concentration. However, the higher alloying concentration presents …

The hot deformation behavior of an Al-Mg-Si-Zr-Mn alloy was investigated by performing
uniaxial compression tests over a temperature range of 400–550° C and strain-rate range of …

A recently developed 7A99 Al alloy was subjected to hot extrusion, solid solution and
artificial aging. The microstructure evolution and precipitation behavior were examined, and …

The content of Zn and Mg directly influences the microstructure characteristics of Al–Zn–Mg–
Cu alloys. In the present study, the solidification phases of three as-cast Al–Zn–Mg–Cu …

The evolution mechanism of the second phase in the homogenization process of Al-Zn-Mg-
Cu aluminum alloy was thoroughly investigated. The results revealed that the phase …

The formation mechanism of intermetallic compounds (IMCs) during dissimilar friction stir lap
welding (FSLW) of Mg and Al alloys, as well as the effects of IMCs on the shearing …