Model predictive current control (MPCC) is a high-performance control strategy for
permanent-magnet synchronous motor (PMSM) drives, with the features of quick response …

Finite-state predictive torque control (FS-PTC) is computationally expensive, since it uses all
voltage vectors (VVs) available from a power converter for prediction and actuation. The …

Predictive torque control (PTC) is based on the prediction of motor torque and stator flux for
all possible voltage vectors of power converter. These predictions are derived from a …

Conventional finite control set-model predictive control (FCS-MPC) applies single voltage
vector within each control period. This leads to relatively high steady-state ripples and …

To reduce the computation burden and eliminate the weighting factor in conventional speed
prediction control, a direct voltage-vector selection-based model-predictive direct-speed …

The conventional model predictive control method suffers from large torque ripples and
harmonic current. Moreover, the modulation range of output is limited, leading to the …

The performance of a standard model predictive controller (MPC) is directly related to its
predictive model. If there are unmodeled periodic disturbances in the actual system, MPC …

As a result of their reduced number of switches, three-phase four-switch (TPFS) inverters are
generally applied as cost-reduction topologies for permanent magnet synchronous motor …

In this paper, a new duty cycle control method is proposed to reduce torque and flux ripples
of the conventional direct torque control (DTC). In the proposed method, a new approach is …

The direct torque control (DTC) is widely used in motion control of electric drives, especially
for the switching table based direct torque control (ST-DTC) and the space vector …