Realizing higher operating temperatures to increase efficiency of future applications for
energy conversion and storage while minimizing cost is a challenge for development of high …

Internal oxidation was employed to determine oxygen permeability in the Fe-Ni system
between 1000 ºC and 1150 ºC at the oxygen partial pressures of Fe/FeO equilibrium. Fe-Ni …

The high-temperature oxidation behaviour of Fe-Ni-Cr-Al and Ni-Cr-Al alloys with and
without Cu addition was investigated at 1000° C in air to determine the effect of Cu on the …

Abstract Model alloys Ni-(20, 30) Cr (wt%) with (0, 1, 5, 15%) Fe were reacted with Ar-20CO
2-20H 2 O gas at 650 and 700° C. Samples were electropolished to avoid sub-surface cold …

To produce next-generation bonded coating composites for extremely high-speed laser
cladding (EHLC) applications, there is an urgent demand to overcome the problems of …

Grain-boundary oxides formed in advanced high-strength steels during hot-rolled coil can
seriously impair the formability and the surface quality of coatings. In this paper, the effect of …

The corrosion behavior of four Fe-Cr-Ni austenitic alloys were investigated after exposure to
deaerated supercritical water (SCW) at 650° C. Results show that the corrosion resistance …

Poor oxidation resistance is a key contributor to material failure within extreme
environments. Understanding oxygen solubility is important for computation aided design of …

Three FeCrAl alloys and two chromia-formers (a stainless steel, and a Ni-base alloy) have
been exposed in four environments (dry air, air+ 20% H2O, 20% H2+ 20% H2O+ Ar and …

The effect of hydrogen on oxygen permeability has been studied in a diluted Pd–Cr alloy in
dual-and single-atmosphere conditions between 600 and 950° C. The 0.3 mm thick Pd–1.5 …