The tribological performance of Alumina and Molybdenum di Sulphide (MoS 2) reinforced
hybrid Aluminium matrix composites of are carried out in this study. Lubrication is needed …

Multi-objective optimization technique has become an essential step in the selection of
cutting parameters. The intension of this research study is to analyze the performance …

High strength, high ductility, low thermal conductivity and high work hardening effects of
austenitic stainless steels are the foremost factors that make their machinability difficult …

The purpose of the investigations was to assess the influence of repeated sleeve assembly
on the wear of forced-in joint elements. The test methodology assumed operating a forced-in …

In this work, the diamond-like carbon and titanium nitride (DLC/TiN) multilayer coatings were
prepared on a cemented tungsten carbide substrate (WC—3 wt.% Co) using the cathodic …

The impact of cutting parameters on the SR of machined work piece and tool flank wear
during machining of AISI 420 martensitic stainless steel is studied in the research study …

The main target of this research is to examine the performance characteristics of uncoated
and coated tungsten carbide-cobalt rock cutting bits on their calculated output responses in …

In the current study, the effect of SiC and fly ash particles on the mechanical and tribological
behavior of Al 7075 composites has been studied as a replacement for a conventional …

Dry sliding performance of Cu-11Ni-4Si/10wt.% Al 2 O 3 graded composite was investigated
statistically and experimentally using pin-on-disc wear tester. Microstructural analysis …

In precision machining, it is necessary to predict tool wear and estimate the remaining useful
life to produce high-quality products at a low cost. To meet this need, it is necessary to …