The article presents an original technique that does not require the use of specialized
laboratory equipment for measuring the melt flow rate of a composite filament obtained as a …

The mechanical properties improving filler introduction into polymer filaments often lead to
the formation of defects in 3D-printed products. Studying the bulk modification of …

Dynamic modeling of the polymodal morphological structure of the polymer surface, with
modified polyethylene terephthalate as an example, was performed. In particular, the …

The fabrication of poly (oxymethylene) by means of additive manufacturing is still a
problematic procedure due to the low adhesion with standard printing plates and extended …

В работе осуществлено структурно-динамическое моделирование полимодальной
морфологической структуры поверхностей полимеров на примере модифцированного …