An experimental investigation on the role of solution time during the T6 heat treatment on the
scale of the secondary dendrite arm spacing (λ 2), morphology and distribution of Si …

The development of alloys suitable for engine bearings demands not only reducing the
amount of wear as well as increasing the load carrying capability due to both engines …

The addition of third elements to Al-based monotectic alloys can increase the alloy load
capacity, and depending on the nature of the third element can also improve the tribological …

The phase transformations in Al-Cu-Si-Sn alloys were studied using both thermodynamic
calculations and experimental methods. The calculated isothermal and vertical sections …

Abstract Al–Cu–Ni alloys are of scientific and technological interest due to high strength/high
temperature applications, based on the reinforcement originated from the interaction …

Abstract The cast Al4· 4Cu0· 6Mn alloy samples were subjected to quenching at 530° C for
14 h, followed by aging treatment at 170° C for 6, 8, 10, and 12 h. The effects of aging …

Приведен краткий исторический экскурс по антифрикционным сплавам с подробным
рассмотрением алюминиевых сплавов для биметаллических и монометаллических …

The segregation behavior of a rheological high pressure die-casting (Rheo-HPDC)
AC46000 aluminum alloy at positions with different wall thicknesses was studied. The …

Aluminum alloys with soft elements are quite promising in the automotive industry for
manufacturing machine elements subjected to relative motion. The combination of some …

The preprogramming of the solidification cooling rate during casting of some Al-based
bearing materials, has been used to achieve microstructural patterns conducive to better …