As a most widely applied structure material, the deformed characteristics of steels primarily
presented the adiabatic shear band (ASB) formation and phase transitions, instead of its …

Hot compression experiments of a Ti55511 titanium alloy are conducted to study the phase
transformation characteristics and dynamic recrystallization (DRX) behavior. It is found that …

Microstructural evolutions during reversion annealing of a plastically deformed AISI 316
stainless steel were investigated and three distinct stages were identified: the reversion of …

Using thermal-mechanical treatments, specimens with different grain sizes were produced
for two Cr-Ni-based austenitic stainless steels with different stacking fault energies …

In this study, the microstructure-texture-mechanical properties relationships in AISI 304
austenitic stainless steel processed by asymmetric cold rolling investigated. With increasing …

A hierarchical metastable austenitic stainless steel (ASS) is obtained through severe
asymmetric cold rolling (about 92% reduction) and reversion annealing. The microstructure …

Macrostructure, microstructure, and distribution of phases through the interface were
analyzed for friction-stir-welded joints 5083 aluminum alloy and 316L steel. Several …

This research presents the microstructural and mechanical evolution throughout the welded
seam of an austenitic stainless steel (ASS) tube. It was found that the main hardness …

A sheet-shaped austenitic stainless steel (ASS) was processed by one ECASE pass. In this
way, larger deformations were introduced close to the sheet edge vicinities, while the middle …

An advanced thermomechanical process based on the formation and reversion of
deformation-induced martensite was used to refine the grain size and enhance the hardness …