Extreme pressure (EP) and antiwear (AW) additives are necessary for boundary lubrication.
However, their mechanisms and physical and chemical properties remain unclear. EP and …

Many implant materials have been used in various dental applications depending on their
efficacy and availability. A dental implant must possess the required characteristics, such as …

This study aims at assessing the effect of solution heat treatment (at a temperature just
below the eutectic temperature) followed by various cooling rates on the microstructure and …

The high entropy nitride coatings (Cr 0.35 Al 0.25 Nb 0.12 Si 0.08 V 0.20) N with high
hardness of 35 GPa and a high H 3/E 2 of 0.52 were fabricated by RF magnetron sputtering …

Tribology at cryogenic temperatures has attracted much attention since the 1950s with the
acceleration of its applications in high-tech equipment such as cryogenic wind tunnels …

Lightweight foam concrete is an appealing thermal insulation material with great potential for
decarbonizing the building sector, given that its superior thermal insulation and reduced …

In this paper, the processing-structure-property correlation of a high-strength titanium-
modified aluminum-copper alloy, ie, Al–Cu–Mg–Ag–Ti–B (A205), in the laser powder-bed …

This paper focuses on the effect of melting modes on microstructural evolution and
tribological properties of AlSi10Mg alloy fabricated by selective laser melting (SLM). The …

The effect of the mechanical properties of CrN/CrCN multilayer ceramic coatings on
cavitation degradation and surface roughness was investigated. Three coatings with …

Highly loaded wear components in manifold applications such as sieves, crushers, etc.
suffer from combined impact and abrasive wear. To gain deeper understanding of different …