Corrosion induced by chlorine during biomass combustion is a major drawback to the
consolidation of this technology. The current literature brings valuable information on these …

The mechanical alloying method is widely used for production of powdered alloys. However,
focused studies have shown that this method may also be used for deposition of coatings …

Abstracts In this paper, in order to improve the carbon steel service condition in a severe
high-temperature wear field, a novel and dense NiAl/WC (NiAl-20% wtWC) and NiAl/WC-Fe …

The microstructure, morphology, micro hardness and electrochemical properties of the
deposited Ni-Al coating on the surface of hypoeutectoid steel, Nickle, Aluminum and …

Fabrication of a newly nanocrystalline Al and two of its alloys, namely Al–10% Cu; and Al–
10% Cu–5% Ti has been carried out using mechanical alloying (MA) technique. The …

Using initial powder mixtures with different Ni: Al 2 O 3 weight ratios ranging from 1: 1 to 16:
1, nano structured Ni-Al 2 O 3 composite coatings were deposited onto an aluminum plate …

The present study aims at investigating the effect of pre-milling nickel (Ni) and aluminium
(Al) powders on the sintering behaviour of NiAlFeCoCr high entropy alloys (HEA). As-milled …

The microstructures, tribo-mechanical properties of the fabricated NiAl/Cr 2 AlC composite
coatings with various additions of self-made Cr 2 AlC were comparatively investigated. The …

In this study, the influence of silicon carbide (SiC) content on microstructure and oxidation
behavior of the Al 50 (Fe–Cr)(50-x)(SiC) x composite coating on low-carbon steel was …

Abstract Graphene nanoplatelets (0.5–1 wt.%) reinforced nickel aluminium (NiAl) coating
has been fabricated using shroud plasma spray technique in a quest to achieve an …