Low-profile all-textile multiband microstrip circular patch antenna for WBAN applications
A compact low-profile all-textile multiband antenna operating in the 2.45/5.8 GHz ISM bands,
mobile WiMAX IEEE 802.16 2005 (3.3–3.4 GHz), and 5G sub-6 NR frequency band n77 …
mobile WiMAX IEEE 802.16 2005 (3.3–3.4 GHz), and 5G sub-6 NR frequency band n77 …
On comparison of recycled LDPE and LDPE–bakelite composite based 3D printed patch antenna
In the past two decades number of studies have been reported on the use of thermoplastics
as a substrate for 3D printed patch antennas. However, no work has been reported on the …
as a substrate for 3D printed patch antennas. However, no work has been reported on the …
Flexible MIMO Antennas for 5G Applications
NP Kulkarni, NB Bahadure, PD Patil… - … on Emerging Trends …, 2022 - ieeexplore.ieee.org
5G is emerging as a next-generation technology that enhances capacity, provides very low
latency, very high data rates, and good quality of service. For any 5G device to operate …
latency, very high data rates, and good quality of service. For any 5G device to operate …
Design and analysis of circular patch antenna for WBAN at terahertz frequency
A compact circular patch antenna operating at terahertz frequency is presented. Designed
antenna has a substrateof length 100 μm, width of 100 μm and thickness of 10μm. Radius of …
antenna has a substrateof length 100 μm, width of 100 μm and thickness of 10μm. Radius of …
Novel electro-textile patch antenna on jeans substrate for wearable applications
This paper aimed to take closer steps towards real wearability by investigating the
possibilities of designing and fabricating highly efficient and fully flexible wearable microstrip …
possibilities of designing and fabricating highly efficient and fully flexible wearable microstrip …
Design and optimization of THz antenna for onbody WBAN applications
A Rajawat, SH Gupta - Optik, 2020 - Elsevier
This paper presents a design and analysis of microstrip antenna operating in Terahertz
frequency band with dumbbell slots cut on the ground. Compactness and gain of the micro …
frequency band with dumbbell slots cut on the ground. Compactness and gain of the micro …
Circuit modeling and analysis of wearable antennas on the effect of bending for various feeds
S Mallavarapu, A Lokam - Engineering, Technology & Applied Science …, 2022 - etasr.com
The promising utilization of wearable antennas has experienced gigantic growth during the
last decade. An antenna is one of the most significant and crucial components of wireless …
last decade. An antenna is one of the most significant and crucial components of wireless …
Wearable inset-fed fr4 microstrip patch antenna design
SRM Zaini, KNA Rani - IOP Conference Series: Materials …, 2018 - iopscience.iop.org
This project proposes the design of a wireless body area network (WBAN) microstrip patch
antenna covered by the jeans fabric as the outer layer operating at the center frequency, fc …
antenna covered by the jeans fabric as the outer layer operating at the center frequency, fc …
[HTML][HTML] Comparative study of textile material characterization techniques for wearable antennas
A comparative study of Quarter-wavelength λ4 stub and ring resonator techniques for the
characterization of four (4) different textile materials (Kente-Oke (M1), Sanya (M2), Alaari …
characterization of four (4) different textile materials (Kente-Oke (M1), Sanya (M2), Alaari …
Numerical and experimental investigation of the opposite influence of dielectric anisotropy and substrate bending on planar radiators and sensors
The simultaneous influences of the substrate anisotropy and substrate bending are
numerically and experimentally investigated in this paper for planar resonators on flexible …
numerically and experimentally investigated in this paper for planar resonators on flexible …