The hot ductility of Transformation Induced Plasticity (TRIP) and Twinning Induced Plasticity
(TWIP) steels is reviewed, concentrating on the likelihood of cracking occurring on …

The deformation and fracture behaviors of as-cast AZ31B Mg alloy were studied by uniaxial
compression experiments and finite element simulations with wide ranges of temperature …

In this paper, the influence of small additions of Cr, Mo, Cu, Ni, B, Ca, Zr, and Ce on the hot
ductility of advanced high-strength steels (AHSS) has been reviewed. Most of these small …

Abstract Effect of Mn (14.94, 18.21, and 23.6 wt%) and Al (0.002, 0.75, and 1.47 wt%)
contents on hot ductility of five high alloy Fe-xMn-C-yAl austenitic Twinning induced …

The hot ductility of twin induced plasticity (TWIP), 0· 6 wt-C steels containing 18–22 wt-Mn
with N levels in the range 0· 005–0· 023 wt-and the Al additions either low (< 0· 05 wt-) or …

This work aims at the development of carbon steel AISI 1536 through the microalloying
addition of boron. Three grades of this steel with different content of boron up to 0.0055 …

Central cracking in cross-wedge-rolled workpieces results in high wastage and economic
loss. Recent cross-wedge rolling tests on two batches of steel showed that one batch formed …

Carbidic austempered ductile iron (CADI) castings provide a unique combination of high
hardness and toughness coupled with superior wear resistance properties, but their …

The hot ductility of a Fe-0.3 C-9Mn-2Al medium Mn steel was investigated using a
Gleeble3800 thermo-mechanical simulator. Hot tensile tests were conducted at different …

The hot ductility behavior of AZ81 magnesium alloy, as a typical Mg–Al–Zn base cast alloy
with high Al content, has been studied through applying a set of low strain rate hot tensile …