Objective The objectives of the study were to assess the survival, failure, and technical
complication rates of implant‐supported fixed dental prosthesis (iFDPs) with pontic or …

Objectives To investigate crystallography, translucency, phase content, microstructure and
flexural strength of two commercial strength-gradient multilayered dental zirconia grades …

The aim of the present study was to evaluate the fatigue to cyclic and static resistance of
indirect restorations with different preparation designs made either of lithium disilicate (LS) …

This study compared the flexural strength under monotonic (static-sσ) and cyclic load
application (fatigue-fσ), hardness (H) and fracture toughness (K IC) of different layers of a …

Statement of problem The mechanical properties of 3 dimensionally (3D) printed zirconia
have been reported to be comparable with those of milled zirconia, except for the flexural …

Objectives To compare the mechanical properties of different layers of multi-layered zirconia
materials. Methods 720 cylindric test plates were fabricated from four defined layers of three …

(1) Background: Due to advantages such as avoidance of chipping, pulp-friendly tooth
preparation and cost reduction, zirconia is increasingly being used monolithically without …

The aim of this study was to evaluate the fatigue behavior of strength-graded zirconia
polycrystals used as monolithic three-unit implant-supported prosthesis; complementarily …

Background: Classic endocrowns made of dental ceramics are considered a promising
alternative to traditional post-endodontic restorations. The use of circular ferrules in …

This study evaluated fracture resistance of monolithic fixed dental prostheses (FDPs)
fabricated using different placement strategies of various connector designs in multilayered …