Owing to their unique properties, the electrochemically self-organized TiO 2 nanotube arrays
(TNTAs) have attracted great attention as promising nanomaterials for energy and …

Since its inception in 1989, scanning electrochemical microscopy (SECM) has been used to
investigate the localized corrosion of systems with high spatial and temporal resolution. This …

In this paper, Fe was strategically replaced by Mo in the laser cladded Co 20 Ni 20 Cr 16 Fe
19-x Mo x B 15 Si 10 (x= 0, 4, 8, 12, 16 at.%) high-entropy alloy (HEA) coatings via tuning …

We describe the interfacial characteristics of a Ti-6Al-4V alloy fabricated using laser powder-
bed fusion (L-PBF) upon exposure to a corrosive environment and tribocorrosion conditions …

In this study, carbon nanotubes with Fe cores (Fe-CNTs) were successfully prepared by the
vapor deposition method, which used raw coal as a carbon source. The brookite crystal Ti3+ …

Due to many limitations of titanium oxide, its direct use in photoelectrochemical water
splitting under solar radiation is ineffective. Band gap engineering based on introduction of …

The long term electrochemical corrosion behavior and passive film properties of a novel
dense Fe48Cr15Mo14C15B6Y2 (at.%) amorphous coating were investigated using …

The current study investigates the effect of crystallite size and surface morphology of TiO 2
nanotubes on their wettability and electrochemical properties. Self-organized amorphous …

Nanotube structures were produced on the titanium surface by anodization using an
aqueous electrolyte composed of carboxymethylcellulose (CMC) and NaF. The aim of using …

Hydrogen atoms accumulate in the grain boundaries, dislocations and twins of metals, but
the Fe-based amorphous coatings do not have these crystal defects. The effect of hydrogen …