Because of rapid solidification involved in the laser or e-beam based additive manufacturing
(AM) process, solution treatable metallic parts made by these methods usually possess a …

Abstract Outdoor applications of Al–Mg–Si alloys have been specified due to their very good
corrosion resistance when compared with those of other aluminum alloys. Nevertheless …

The effects of different cooling rates (0.3–66.2 K/s) on the solidification behavior,
microstructural evolution, and mechanical properties of Al–Zn–Mg–Cu alloys during a short …

In this study, a Ni-based Hastelloy C276 alloy was prepared using cold metal transfer (CMT)-
based directed energy deposition (DED) under different heat inputs with a zig-zag …

In the present work, the microstructural evolution and mechanical property of as-cast Al–6
Mg–0.8 Mn alloys with respect to the solidification cooling rate was investigated. The results …

The powder-bed laser additive manufacturing (AM) process is widely used in the fabrication
of three-dimensional metallic parts with intricate structures, where kinetically controlled …

Al alloys are very attractive in engineering applications that require a combination of low
density and mechanical strength, such as in aeronautical and aerospace industry devices …

The aging behavior of Al matrix composites reinforced with high content nano-
reinforcements has been rarely reported. In the present work, the aging behavior of 15 vol …

The machinability in turning of Al-Si-Mg alloys under as-cast and heat-treated conditions has
been investigated. Three alloys with 3%, 7% and 12% Si and 0.6% Mg contents (wt%) were …

In this study, to clarify the evolution mechanism of dendrite structure and shrinkage porosity
in 30Cr15Mo1N ingots under varying pouring rates, the changes in cooling rate …