Abstract Al–Zn–Mg–Cu alloys can be fabricated by a series of thermo-mechanical
processing methods (eg, hot rolling, forging and extrusion), which is able to serve in …

High temperature tensile and electron backscatter diffraction (EBSD) techniques were
combined to perform a systematic investigation for the hot deformation behavior and …

The microstructure, hardness and corrosion resistance of aluminum alloy 7085 after different
retrogression and re-aging (RRA) treatments were investigated. The results showed that the …

High-temperature flow features of the Al− Zn− Mg− Cu− Zr aluminum alloy was revealed by
hot compression tests. The evolution mechanisms of dislocation clusters, subgrain, and …

Hot compressive tests of a nickel-based superalloy are performed under the strain rate
range of 0.001–1 s− 1 and deformation temperature range of 920–1040° C. Optical …

A detailed analysis of work-hardening behavior is useful to optimize the hot forming
processing of metals or alloys. The hot compression tests of solution-treated and aged Ni …

This short communication presents 2–4 μm sized TiCN reinforced AlSi10Mg composites
(TiCN/AlSi10Mg) fabricated by laser powder bed fusion (LPBF) with refined Al-Si eutectic …

Titanium alloy, TA15, has a high strength-to-weight ratio, high weldability, and superior
creep resistance at high temperatures up to 550° C. TA15 is difficult to deform, especially for …

Commercial simulation software like QFORM and DEFORM do not possess adequate
material data for alloys produced through powder metallurgy. Therefore, in the present …

Hot compression tests in the temperature range of 493-653 K and strain rates of 0.01-10.00
s− 1 were used to evaluate the hot deformation behavior of 60Mg-30Pb-9.2 Al-0.8 B alloy. In …