The addition of distributed generation to a power system improves its performance. It makes
it more sustainable and efficient. But it also poses substantial challenges for designing a …

Compared to AC microgrids, DC microgrids have the advantage of higher reliability and
efficiency and are convenient to connect with various distribution energy resources (DERs) …

With an increasing number of distributed energy resources integrated into the power system,
inverters need to take on the corresponding responsibility for the security and stability of the …

High-impedance faults (HIFs) pose the greatest challenge for distribution system protection,
especially for microgrids and distribution networks with distributed generators (DGs) that …

Active power oscillation is observed when two or more parallel synchronverters undergo
load fluctuations, potentially impacting the safe operation of the synchronverters. This article …

Medium power distributed energy resources (DERs) are commonly connected to medium
voltage distribution systems via voltage source converters (VSCs). Several guidelines and …

With development of power electronic technology, the paralleled current-controlled voltage
source converters (CCSs) and virtual synchronous generators (VSGs) system has …

Fault ride through compliance as imposed by grid codes prevents undesirable
disconnection of renewable plants from the network even during fault. Diversified control …

The accurate analytical fault analysis model of the emerging inverter-interfaced renewable
energy sources (IIRESs) is an important basis for protection of power system with RESs …

Three-phase four-wire grid-forming (GFM) inverters are promising to interface distributed
energy resources into low-voltage networks. However, these inverters are prone to …