Rolling contact fatigue (RCF) of sprayed coating is complicated process relating to materials,
structures, loading conditions, etc. Herein, the research works over the past decades in RCF …

Gradient nanostructure layer (GNL) is machined on 7075-aluminum by the ultrasonic-
assisted surface burnishing (UASB) setup. Compared with the traditional burnishing, the …

Two kinds of Fe-based amorphous alloy coatings were fabricated by high velocity oxygen
fuel (HVOF) spraying and cold spraying (CS). Microstructure, amorphous content, hardness …

To investigate the influences of phase transition temperature and preheating on the residual
stress of multi-layer and multi-pass laser metal deposition (LMD), the multi-layer and multi …

Laser additive manufacturing is an ideal choice to fabricate metal parts with complicated
geometric shapes. In this research,(Fe 60 Co 35 Ni 5) 73.5 Si 13.5 B 9 CuMo 3 magnetic …

Abstract Fe-Cr-Ni-Mn-Mo-Nb-Si steel with low transformation temperature was fabricated by
direct laser deposition (DLD) and its microstructure, residual stress and properties were …

High wear between surfaces may lead to an increase of cost of production in mechanical
engineering industry. To solve this problem, Fe-based amorphous coatings prepared using …

Silicon nitride ceramics (Si 3 N 4) and (TiB+ Y 2 O 3)/titanium matrix composites (TMCs)
were brazed using a multilayered filler consisting of AgCu foils and Cu foam. The …

In order to reveal the roles of stress in the thermal shock failure of thermal barrier coatings
(TBCs), yttria-stabilised zirconia (YSZ) TBCs were prepared via atmospheric plasma …

It is a big challenge to ensure the low energy consumption and stability of the hybrid
mechanism under the dynamic load condition, and it is more obvious in the series-parallel …