[HTML][HTML] Heat treatment of aluminium alloys produced by laser powder bed fusion: A review
Laser powder bed fusion (LPBF) is the most widely used additive manufacturing technique
and has received increasing attention owing to the high design freedom it offers. The …
and has received increasing attention owing to the high design freedom it offers. The …
Solidification microstructure simulation of Ti-6Al-4V in metal additive manufacturing: A review
Metal additive manufacturing (MAM) technology is now changing the pattern of the high-end
manufacturing industry, among which microstructure simulation gradually shows its …
manufacturing industry, among which microstructure simulation gradually shows its …
Contribution of Mg2Si precipitates to the strength of direct metal laser sintered AlSi10Mg
Microstructure of deformed DMLS-AlSi10Mg under quasi-static loading was studied using
TEM to elaborate the strengthening mechanisms. In addition to Orowan (due to presence of …
TEM to elaborate the strengthening mechanisms. In addition to Orowan (due to presence of …
[HTML][HTML] Design of solute clustering during thermomechanical processing of AA6016 Al–Mg–Si alloy
Solute clustering is a technologically important microstructural process in Al alloys. Exerting
control over this process to enhance the alloy properties and reduce the energy costs of …
control over this process to enhance the alloy properties and reduce the energy costs of …
Analysis of the metastable precipitates in peak-hardness aged Al-Mg-Si (-Cu) alloys with differing Si contents
The peak-hardness aged (T6) precipitates in 6061 (Mg: Si≈ 2: 1) and Si-enriched 6061 (Mg:
Si≈ 1: 1.1) alloys have been characterized using transmission electron microscopy and …
Si≈ 1: 1.1) alloys have been characterized using transmission electron microscopy and …
Study of precipitation in Al–Mg–Si alloys by Atom Probe Tomography I. Microstructural changes as a function of ageing temperature
MW Zandbergen, Q Xu, A Cerezo, GDW Smith - Acta Materialia, 2015 - Elsevier
Abstract Atom Probe Tomography (APT) analysis and hardness measurements were used to
characterise the early stages of precipitation in an Al–0.51 at.% Mg–0.94 at.% Si alloy. The …
characterise the early stages of precipitation in an Al–0.51 at.% Mg–0.94 at.% Si alloy. The …
Cluster evolution mechanisms during aging in Al–Mg–Si alloys
Abstract Using Atom Probe Tomography (APT) and Phase Field Crystal (PFC) modelling, the
early-stage precipitation phenomenon is investigated for naturally-and artificially-aged Al …
early-stage precipitation phenomenon is investigated for naturally-and artificially-aged Al …
Issues in fabrication of 3D components through DMLS Technique: A review
Abstract DMLS or Direct Metal Laser Sintering is a technique which can be classified under
an additive manufacturing (AM). In this technique, metal powders are used to manufacture …
an additive manufacturing (AM). In this technique, metal powders are used to manufacture …
Rapid solidification and non-equilibrium phase constitution in laser powder bed fusion (LPBF) of AlSi10Mg alloy: analysis of nano-precipitates, eutectic phases, and …
The non-equilibrium phase evolution during laser powder bed fusion (LPBF) of AlSi10Mg
alloy is thoroughly characterized and analyzed by means of advanced electron microscopy …
alloy is thoroughly characterized and analyzed by means of advanced electron microscopy …
Advancements in the additive manufacturing of magnesium and aluminum alloys through laser-based approach
Complex structures can now be manufactured easily utilizing AM technologies to meet the
pre-requisite objectives such as reduced part numbers, greater functionality, and lightweight …
pre-requisite objectives such as reduced part numbers, greater functionality, and lightweight …