Polymer electrolyte membrane (PEM) fuel cells demonstrate potential as a comprehensive
and general alternative to fossil fuel. They are also considered to be the energy source of …

In this work, a computationally efficient approach for the simulation of a DC-DC converter
connected to a photovoltaic device is proposed. The methodology is based on a …

Critical conduction mode (CrCM) active clamp flyback (ACF) converter is regarded as a
good candidate for low power adaptor applications. However, the most adopted control …

This work presents a power-electronics based system for renewable energy applications,
the system is driven with an only one switch quadratic type boost converter, the discussed …

This paper deals with the modeling and cross-coupling effect analysis in double-input Boost
converters with multiplex current control. A ripple-based multiplex current controlled matrix …

In this paper, a bidirectional non-isolated hybrid modular DC–DC converter for high-voltage
(HV) applications is investigated. In this configuration, conventional Half-Bridge Sub …

Peak-current-mode (PCM) control was published first time in open literature in 1976. The
observed peculiar behavior caused by the application of PCM control in a power electronic …

As for ripple-current mode control, it cannot achieve average current tracking, resulting in
poor current accuracy and even current waveform distortion. Meanwhile, fast-scale instability …

Digital average-ripple-based (AR) control techniques, which are categorized in digital
average inductor current (DAIC) control, digital average voltage (DAV) control, and digital …

A large-signal averaged model is obtained to analyze the startup response of a boost
converter loaded with a constant power load (CPL) and a peak current mode control (CMC) …