This book presents the state of the art of the synthesis of materials, composites, and
chemical compounds, and describes methods based on the use of ionizing radiation. It is …

Mechanical alloying of blended chromium and cobalt powders is carried out in order to
obtain a nanostructured Cr–10Co alloy. The alloy formation is studied by means of scanning …

In the current study, the properties of the CrxN coatings deposited on the Inconel 718
superalloy using direct current reactive magnetron sputtering are investigated. The influence …

This review summarizes the results of studies on the structure and tribological characteristics
of Cr-N, Ti-N, and VN thin films obtained using ion-beam-assisted deposition (IBAD) method …

В обзоре систематизированы результаты исследований последних 25 лет в области
получения и применения Cr–N-покрытий, создаваемых с помощью вакуумно-дуговых …

Stainless steel 304L coatings were deposited at a low temperature on AZ31B magnesium
alloy by magnetron sputtering, both with and without the use of Ar+ ion bombardment during …

The paper generalizes the results of investigations performed at the Kharkov Institute of
Physics and Technology, National Scientific Center, aimed at the development and analysis …

The initial stages of formation of VN–Ar/He nanocrystalline thin films that were obtained
using ion beam-assisted deposition technology have been investigated. It has been shown …

The influence of the helicon discharge on the formation of the relief and chemical
composition of the surface of single phase brass L63 is investigated. Two stages of …

This scientific paper describes the structure, phase composition and mechanical properties
of nanocrystalline coatings obtained using the ion beam-assisted deposition technology …