Abstract Although Ni–Ti–O nanopores (NPs) can be fabricated by anodization of
mechanically polished NiTi alloys, the top disordered layer is difficult to remove thus …

This work reports on the electrodeposition of zinc on nanoporous metal oxide titania
nanotube arrays (TiO2 NTAs) using a zinc-containing deep eutectic solvent (Zn2+–DES) …

The charge-storage kinetics of amorphous TiO x nanotube electrodes formed by anodizing
three-dimensional porous Ti scaffolds are reported. The resultant electrodes demonstrated …

The performance of the Lithium Ion Batteries (LiBs) is significantly influenced with the
synergetic chemical properties of two different materials in a composite form. The specific …

TiO 2 has recently been attracted for use as anode material in lithium ion batteries (LIBs).
However, its drawbacks are poor electrical conductivity and low intrinsic diffusivity of Li ions …

Fabrication strategies for TiO 2 nanotube (NT) electrodes were optimised with an aim to
improve the understanding of the material attributes required for enhanced areal capacity …

Room temperature positive magnetoresistance (PMR) in graphene is a conventional
phenomenon but we observed large negative magnetoresistance (NMR) in GF …

Titanium type lithium ion‐sieve nanotubes synthesized by the hydrothermal method were
extensively explored over recent years due to its promising properties. However, on account …

TNAs (Titanium dioxide nanotube arrays) were synthesized by electrochemical anodization
and these TNAs were annealed in different gas atmosphere such as argon, air, hydrogen …

In this work, TiO 2 nanotubes were successfully prepared by using TiO 2 nanoparticles as
the precursor through a simple hydrothermal method followed by calcination. The phase …