Indirect monitoring of machining characteristics via advanced sensor systems: a critical review

ME Korkmaz, MK Gupta, Z Li, GM Krolczyk… - … International Journal of …, 2022 - Springer
On-line monitoring of the machining processes provides to detect the amount and type of
tool wear which is critical for the determination of remaining useful lifetime of cutting tool …

Optimization of cutting parameters affecting surface roughness in turning of inconel 625 superalloy by cryogenically treated tungsten carbide inserts

M Akgün, H Demir - SN Applied Sciences, 2021 - Springer
This work focuses on developing the mathematical model of surface roughness (Ra) in the
turning of Inconel 625 superalloy with cryogenically treated tungsten carbide inserts. The …

Modelling and optimization for thrust force, temperature and burr height in drilling of custom 450

H Gökçe - Experimental Techniques, 2022 - Springer
The low heat conduction values and high mechanical properties of stainless steels, which
have high resistance to corrosion, make them difficult to be machined. Custom 450, a …

Experimental and statistical investigation of the effects of cutting parameters on kerf quality and surface roughness in laser cutting of Al 5083 alloy

B Özlü - Surface Review and Letters, 2021 - World Scientific
In this study, the effect of cutting parameters on kerf quality and surface roughness in laser
cutting of Al 5083 alloyed material was investigated both experimentally and statistically …

Estimation of surface roughness and flank wear in milling of Inconel 625 superalloy

M Akgün, H Demir - Surface Review and Letters, 2021 - World Scientific
The main objective of this work is to experimentally investigate and statistically evaluate the
effects of the milling parameters on surface roughness (Ra) and flank wear (Vb) in the …

Mathematical modeling and multiresponse optimization to reduce surface roughness and adhesion in Al 5083 H116 alloys used in ammunition propulsion actuators

H Gökçe, MA Biberci - Multidiscipline Modeling in Materials and …, 2023 - emerald.com
Purpose This study aims to obtain the lowest surface roughness (Ra) and drill bit adhesion
values (AV) depending on the change in control factors (cutting speed-Vc, feed rate-f and …

Evaluation of performance of parallel connected vortex tubes using air, oxygen and carbondioxide with Taguchi method

H Kaya - Heat and Mass Transfer, 2021 - Springer
This study involves an optimization procedure for the factors affecting the performance of the
parallel connected vortex tube system using the Taguchi method. The effect of vortex tube …

Optimization of Ranque–Hilsch vortex tube performances via Taguchi method

H Gökçe - Journal of the Brazilian Society of Mechanical Sciences …, 2020 - Springer
In this study, by considering the changes in inlet pressures, connection nozzle materials and
the number of orifices, the performances of Ranque–Hilsch vortex tubes (RHVTs) were …

Investigation of thrust force, drill bit temperature and burr height in the drilling of aluminum alloy used in ammunition wing drive systems

H Gökçe, MA Biberci - Experimental Techniques, 2022 - Springer
In this present study, the effect of drilling parameters and carbide drill bits in drilling of Al
5083 H116 alloy was investigated. The drilling tests were carried out using various carbide …

Effects of Shallow and Deep Cryogenic Treatment on Tool Flank Wear and Surface Roughness in Machining 41Cr4 Steel

N Altan Özbek - Journal of Materials Engineering and Performance, 2023 - Springer
This study presents the affects of cryogenic treatment on flank wear (Vb) and surface
roughness (Ra) in machining 41Cr4 steel with shallow (SCT (15 h at− 80° C)) and deep …