This article investigates the gallium nitride based bridgeless dual single-ended primary
inductor converter (SEPIC) power factor correction (PFC) with full input voltage range zero …

Single-stage (SS) power factor correction (PFC) converters are applied as the power supply
for low-power devices. Usually, the flyback converter is merged with the PFC stage to …

This article presents a BLDC (permanent magnet brushless DC) motor drive for marine
electric vehicle (MEV) application. The presented scheme uses bridgeless canonical cell …

A new isolated bridgeless PFC converter based on active-clamped SEPIC is proposed.
Compared to conventional active-clamped SEPIC PFC converter, the proposed converter …

This article presents the analysis, design, and implementation of a 2 MHz, 12 V, 600 mA,
GaN-based active-clamped isolated SEPIC converter (ACISC) supporting full zero-voltage …

This paper proposes a high-performance isolated single-ended primary inductor converter
(SEPIC) that is integrated with a non-dissipative snubber for a light-emitting diode (LED) …

Due to the characteristics of high power factor and low total harmonic distortion in
discontinuous conduction mode, the power factor correction (PFC) converter based on …

This article proposes a highly efficient quasi-single-stage ac–dc converter that incorporates
a bidirectional switch at the secondary side of the circuit. Its attractiveness is that the …

An increased power factor (PF) frontend battery is used to design a new Electric Vehicle
(EV) charger in this paper. In general, Diode Bridge Rectifier (DBR) is used for generating …

This paper addresses the analysis, design and implementation of a 2 MHz, 12 V, 600 mA,
GaN-based Active-Clamped Isolated SEPIC Converter (ACISC) supporting full ZVS …