This paper presents a comprehensive survey on transmission and distribution fault location
algorithms that utilize synchronized measurements. Algorithms based on two‐end …

In this paper, a simple alternative fault location algorithm for multi-terminal transmission lines
using unsynchronized measurements is proposed. The developed data synchronization …

In this work, a novel fault-locator technique for two-and three-terminal power transmission
lines is introduced. Unsynchronized three-phase current and voltage measurements of all …

This paper proposes a simple, accurate and non-iterative fault location scheme for series
and shunt compensated transmission lines. The proposed algorithm utilizes unsynchronized …

In this paper, a real-time tool to detect transmission line relay mis-operation is implemented.
The tool uses time-synchronized measurements obtained from both ends of the line during …

The tapped lines are usually used to supply a customer such as small communities or
industrial facilities with an economic solution that is less expensive than building a full …

Multi-tapped lines are common in integrated power systems and microgrids which supply
variable loads between the main source and the main load Adopting a cost effective and …

Due to economic reasons, the increase in power demand and available technical
possibilities many 2-terminal lines are being upgraded to 3 or more terminal lines. However …

Wide area measurement systems (WAMS) based fault detection and protection techniques
are gaining more importance with the increase in the number of phasor measurement units …

This paper proposes a simple but effective fault location algorithm for series compensated
transmission lines using unsynchronized two-ended measurements. The data …