Erosion wear performance of WC-10Co4Cr and Cr3C2-25NiCr coatings sprayed with high-velocity thermal spray processes

V Matikainen, SR Peregrina, N Ojala… - Surface and Coatings …, 2019 - Elsevier
Thermally sprayed hardmetal coatings are widely used to protect components and surfaces
against wear in various applications. Hard and wear resistant coatings increase the …

Generative pre-trained transformers (GPT) for surface engineering

S Kamnis - Surface and Coatings Technology, 2023 - Elsevier
The knowledge of scientific articles within Generative Pre-trained Transformers (GPT) is not
exhaustive due to factors such as data coverage, freshness, complexity, paywalls, and …

Cavitation erosion resistance in NaCl medium of HVOF sprayed WC-based cermet coatings at various flow velocities: A comparative study on the effect of Ni and CoCr …

J Lin, S Hong, Y Zheng, W Sun, M Kang, X Fu - International Journal of …, 2021 - Elsevier
High-velocity oxygen-fuel (HVOF) spraying was employed for depositing the WC-10Ni (WN)
and WC-10Co-4Cr (WCC) powders in the form of coatings on 1Cr18Ni9Ti stainless steel …

Microstructure and mechanical property of high velocity oxy-fuel sprayed WC-Cr3C2-Ni coatings

HL Yao, C Yang, DL Yi, MX Zhang, HT Wang… - Surface and Coatings …, 2020 - Elsevier
Abstract WC-Cr 3 C 2-12Ni coatings, with Cr 3 C 2 weight content of 10% and 30%, were
fabricated on steel substrate by high velocity oxy-fuel (HVOF) flame spraying technique, and …

[HTML][HTML] Experimental study of high velocity oxy-fuel sprayed WC-17Co coatings applied on complex geometries. Part A: Influence of kinematic spray parameters on …

V Katranidis, S Gu, B Allcock, S Kamnis - Surface and Coatings Technology, 2017 - Elsevier
When a complex geometry is rotated in front of the thermal spray gun, the following
kinematic parameters vary in a coupled fashion dictated by the geometry: Stand-off distance …

Numerical simulation and parameter sensitivity analysis of multi-particle deposition behavior in HVAF spraying

X Gao, C Li, X Han, X Chen, X Zhao - Surface and Coatings Technology, 2022 - Elsevier
Particle deposition behavior is critical to improve coating quality. Based on the Coupled
Eulerian and Lagrangian (CEL) method, a three-dimensional multi-particle random …

Study of impingement of hollow ZrO2 droplets onto a substrate

A Kumar, S Gu, H Tabbara, S Kamnis - Surface and Coatings Technology, 2013 - Elsevier
In this paper a numerical study comparing the impingement behaviour of a hollow droplet
and an analogous continuous droplet onto a substrate is presented. In the impingement …

Simulation of impact of a hollow droplet on a flat surface

A Kumar, S Gu, S Kamnis - Applied Physics A, 2012 - Springer
Despite many theoretical and experimental works dealing with the impact of dense
continuous liquid droplets on a flat surface, the dynamics of the impact of hollow liquid …

Full-cycle numerical modeling and experimental study of random multiparticle impact in high-velocity air-fuel spraying of titanium alloys

C Li, Z Liu, H Jiang, S Deng, X Han - Journal of Thermal Spray Technology, 2023 - Springer
High-velocity air-fuel (HVAF) spraying can form dense corrosion-and wear-resistant coatings
on the surface of TC18 titanium alloy, solving the problem of protecting aircraft landing gear …

FIB-SEM sectioning study of decarburization products in the microstructure of HVOF-sprayed WC-Co coatings

V Katranidis, S Gu, DC Cox, MJ Whiting… - Journal of Thermal Spray …, 2018 - Springer
The thermal dissolution and decarburization of WC-based powders that occur in various
spray processes are a widely studied phenomenon, and mechanisms that describe its …