Power converter topologies for grid-tied solar photovoltaic (PV) powered electric vehicles (EVs)—A comprehensive review
The transport sector generates a considerable amount of greenhouse gas (GHG) emissions
worldwide, especially road transport, which accounts for 95% of the total GHGs. It is …
worldwide, especially road transport, which accounts for 95% of the total GHGs. It is …
Photocatalytic fuel cells for simultaneous wastewater treatment and power generation: Mechanisms, challenges, and future prospects
Technological advancement is accompanied by excessive consumption of fossil fuels and
affluent uses of chemical substances in many sectors, including transportation and …
affluent uses of chemical substances in many sectors, including transportation and …
Bright future by enhancing the stability of methylammonium lead triiodide perovskites thin films through Rb, Cs and Li as dopants
This paper deals with the doping of methylammonium lead iodide (MAPbI 3) with small
amounts of rubidium (Rb), lithium (Li) and caesium (Cs) to improve the crystallisation of …
amounts of rubidium (Rb), lithium (Li) and caesium (Cs) to improve the crystallisation of …
Effect of deposition cycles on the properties of ZnO thin films deposited by spin coating method for CZTS-based solar cells
The spin-coating technique was used to make ZnO thin films in this study. To get various
thicknesses of ZnO thin film on FTO substrate, the numbers of spin coatings were changed …
thicknesses of ZnO thin film on FTO substrate, the numbers of spin coatings were changed …
Mixed halide head perovskites thin films: Stability and growth investigation
Herein, we investigate the mixed halide perovskite films with the formula MAPbX 3 where (X
3= Br 3, Cl 3, I 3, Br 2 Cl, Br 2 I, and I 2 Cl) prepared by Spin-Coating in order to study the …
3= Br 3, Cl 3, I 3, Br 2 Cl, Br 2 I, and I 2 Cl) prepared by Spin-Coating in order to study the …
Investigation of the surface coating, humidity degradation, and recovery of perovskite film phase for solar-cell applications
Presently, we inquire about the organic/inorganic cation effect on different properties based
on structure, morphology, and steadiness in preparing a one-step solution of APbI3 thin …
on structure, morphology, and steadiness in preparing a one-step solution of APbI3 thin …
A new approach for growing high-quality delafossite CuCoO2 films by spray pyrolysis through the optimization of the Cu/Co ratio
Tremendous advancement in optoelectronic devices can be achieved by the improvement of
high-performing p-type TCOs. Herein, we exhibit the manufacturing of the delafossite …
high-performing p-type TCOs. Herein, we exhibit the manufacturing of the delafossite …
Influence of Sulfur Content in Zn(O,S) Buffer Layer onto Copper Indium Gallium Sulfur-Based Solar Cells Through Surface Engineering at ZnO1−xSx/CIGS Interface
Copper indium gallium sulfur (CIGS) solar cells show good efficiency; however, the
buffer/absorber and absorber/back contact interfaces are the most critical factors affecting …
buffer/absorber and absorber/back contact interfaces are the most critical factors affecting …
Lead-Free BiFeO3-Based Piezoelectrics: A Review of Controversial Issues and Current Research State
Lead-free electroceramics represent an emerging area of research that has the potential to
enable new green advances in electronics. Research has mainly focused on the …
enable new green advances in electronics. Research has mainly focused on the …
Insight into the effect of halogen X in methylammonium lead halide (MAPbX3) spin-coated on zinc oxide film
Herein, we investigated the effect of halogen X in methylammonium lead halide (MAPbX 3)
where X=(Iodide/Bromide, or Chloride) deposited by spin coating technique on a zinc oxide …
where X=(Iodide/Bromide, or Chloride) deposited by spin coating technique on a zinc oxide …