Enhancing the performance of cutting tools is an important factor in reducing production
costs. Cutting tools are subjected to processes such as heat treatment and coating in order …

Increasing environmental legislation necessitates action within the marine industry to reduce
the emission of greenhouse gases, sulphur oxides and nitrogen oxides. Several short …

In this study, a novel cobalt-free Fe 40 Mn 20 Cr 20 Ni 20 (at.%) medium-entropy alloy (MEA)
with low cost is purposively designed. The partially recrystallized microstructure was …

In the present study, a face-centered cubic non-equiatomic Cr 26 Mn 20 Fe 20 Co 20 Ni 14
high-entropy alloy (HEA) with a low stacking fault energy of 17.6 mJ m− 2 was prepared by …

The study is concerned with the mechanical properties of Zn and three Zn–Mg double alloys
with Mg concentrations: 0.5%, 1.0% and 1.5% in the form of rods with a diameter of 5 mm as …

Abstract High strength 2195 Al–Li alloy samples produced by laser powder bed fusion
(LPBF) were obtained in this study. The microstructure and mechanical properties were …

A large-scale billet of 2195 Al-Cu-Li alloy was prepared by spray deposition technology. The
hot extrusion, solution treatment, pre-stretching, and aging treatment were performed on the …

This article describes a technology for the thermomechanical treatment of stainless-steel
piston rings. This technology makes it possible to obtain rings with an optimal combination of …

Abstract 2195 Al-Li alloy billet was prepared by gas atomization (GA) and hot isostatic
pressing (HIP), followed by hot extrusion and different heat treatments. Microstructural …

In this study, the formability and deformation behavior of new third-generation aluminum-
lithium alloys at temperatures ranging from 113 to 298 K were studied by uniaxial tension …