A new low-voltage and low-power noise-cancelling method that employs the local feedback
g m-boosting and balanced loads is proposed by developing a design for a low-noise and …

An inverter-based active feedback CMOS LNA with balun function is within a direct converter
receiver. The LNA has three gain stages. The Multi-gated transistor (MGTR) technique is …

In this article, a blocker-tolerant receiver (RX) front end employing a dual-band-path balun
low-noise amplifier (balun-LNA) is presented for advanced cellular applications. The …

In this paper, a small-signal model of Negative Capacitance FETs (NCFETs) is developed
and the analog performance of NCFETs is studied using the developed model. A new …

This article presents power-efficient radio frequency (RF) receiver designs, particularly for
advanced long-term evolution cellular applications. The two proposed single-ended receiver …

This article proposes a dual-band complementary metal-oxide-semiconductor (CMOS) radio
frequency (RF) front end employing a hybrid transformer-based electrical-balance duplexer …

This paper proposes a second-order input-referred intercept point (IIP2)-enhanced 25% duty-
cycle local oscillator (LO) quadrature passive mixer configuration with developing a …

In this paper, an in-phase (I) and quadrature-phase (Q) balance-enhanced wideband
receiver RF front-end is proposed using a quadrature sampling passive mixer configuration …

This article presents a parallel sliding-IF 5-6-GHz wireless local area network (WLAN)
receiver front-end supporting two-band carrier aggregation (CA), which alleviates potential …

A 0.2–2.6 GHz reconfigurable direct conversion receiver is proposed in this article. The
receiver's high-linearity mode and high-gain mode can be configured by either bypassing or …