The high strength martensite steels are widely used in aerospace, ocean engineering, etc.,
due to their high strength, good ductility and acceptable corrosion resistance. This paper …

The mechanical and corrosion properties of gas metal arc additive manufacturing (GMA-AM)
316L could be optimized by modifying the volume fractions of sigma (σ) and delta-ferrite (δ) …

Stainless steels with high mechanical properties and corrosion resistance are promising
structural materials for the next generation of aerospace and some niche industries. In this …

There are abundant studies on additive manufacturing of Ni alloys, such as Inconel 718.
However, the studies on the microstructure and the deformation behavior of solid solution …

FeCoCrNiMn based high entropy alloys (HEAs) doped with different carbon contents were
prepared by vacuum arc melting. The effects of carbon on phase composition and …

The effect of M 23 C 6 precipitates on the pitting behavior of 0Cr13 martensitic stainless steel
(MSS) was investigated. The results revealed that the precipitates in the 0Cr13 MSS with …

Tellurium treatment is used to control the morphology of manganese sulfide (MnS)
inclusions, reduce the mechanical anisotropy, and improve the machinability of sulfur …

The effect of Cr-rich carbide precipitates on the austenite stability and corrosion behavior of
ultrafine-grained 304 stainless steel obtained by cryogenic rolling and subsequent different …

The pitting corrosion resistance of duplex stainless steel welds was investigated. Pitting
corrosion mainly occurs in high-temperature heat-affected zone (HT-HAZ), where the peak …

After long-term ageing of heat resistant austenitic stainless HR3C steel at 650, 700, and
750° C for up to 30,000 h, microstructural investigations, identification of precipitates, and …