The purpose of this study is to review existing recycling technologies, standards and market
situation for plastics recycling. The principal results show that mechanical recycling is the …

This paper presents the reuse process of post-consumer printed foils made of glycol-
modified poly (ethylene terephthalate)(PETG). Fourier-transform infrared spectroscopy and a …

The current research has produced engineering plastics composite for automotive
applications using waste recycled plastic recycled polyethylene terephthalate (RPET) bottles …

Blends of poly (butylene adipate‐co‐terephthalate)/polyglycolic acid (PBAT/PGA) were
prepared by melt blending, in which PGA was used as reinforcing component. Impacts of …

A fused-deposition modeling (FDM) 3D-printed polyethylene terephthalate glycol (PETG)–
sepiolite composite showed effective synergetic mechanical reinforcement in tensile testing …

As one of the most commonly used thermoplastics, polyester has rarely been used as the
raw materials of 3D printing. However, copolyester obtained by copolymerization modifying …

Unmanned aerial vehicles (UAVs) are at the fore-front of this century's technological shift,
becoming ubiquitous in research and market areas. Similarly, nowadays, 3D printing is a …

This research shows the influence of the crystallinity of thermoplastic polymer matrix on the
mechanical properties of short-fibre composites. It proves that crystal phase affects not only …

In this paper, properties of glass fiber-reinforced thermoplastic polymers (GFRTP) were
evaluated using recycled polyester (rPET) for injection molding bicycle frame. The effect on …

The paper discusses the preparation of polymer blends based on the polyethylene
terephthalate copolymer/polycarbonate (GPET/PC). Materials have been prepared in order …