Mullite, an intermediate phase of the binary alumina-silica system, is one of the most
important phases of ceramic products containing alumina and silica in the initial …

This review article presents the current status of various micromachining techniques used to
create microfeatures in alumina ceramic. Alumina has emerged as an advanced substrate in …

Drinking water treatment sludge (DWTS) was used for the preparation of ceramic
microfiltration membrane. The DWTS powder was firstly characterized to determine its …

The challenge of the scientific community is to synthesize innovative, low-cost, and
environmentally friendly membrane materials for the treatment of industrial wastewater. The …

The use of industrial waste (by-products) as raw materials in the ceramic industry has been
under study for decades due to the economical, energy, tax and environmental advantages …

The exponential growth of industrial waste is a problem that has forced the development of
clean technologies for their appropriate management. About 0.25–0.30 tons of slag is …

Mullite based ceramics were prepared by reaction sintering of mixtures containing kaolin
clay and kaolin waste. Phase composition, apparent density, apparent porosity, and …

This work proposes the mixing of two varieties of Moroccan clay (C1 and C2) with silica sand
in order to minimize the amount of the feldspar used. The raw materials were previously …

Potential use of raw clayey deposits from El Jadida, Morocco, in the manufacture of
traditional ceramic products has been evaluated through a careful sampling and an in-depth …

The present study is a contribution to the valorization of halloysite clay from North Eastern
Rif (Nador, Morocco) in the field of Silica-alumina refractory. For this purpose, six mixtures …