This paper describes an ultra-low power (ULP) single chip transceiver for wireless body
area network (WBAN) applications. It supports on-off keying (OOK) modulation, and it …

Since in most wireless sensor network (WSN) scenarios nodes must operate autonomously
for months or years, power management of the radio (usually consuming the largest amount …

Energy-efficient and cost-effective wireless connectivity is of paramount importance for
Internet-of-Things (IoT) applications and has inspired a lot of research interests lately. Reuse …

Frequency multiplying wireless transmitters (TX) employing harmonic injection-locked
technique benefit from high energy efficiency and less hardware complexity but largely …

An on/off keying receiver has been designed in 90 nm CMOS for low-power event-driven
applications. Thanks to the synchronized-switching technique and power-efficient RF gain …

An ultra-low-power RF envelope-detection radio has been designed for low-power short-
range wireless applications. It introduces an interference rejection technique that improves …

This paper presents a new Class-E power amplifier (PA) with a π-matching output network.
The PA is targeted at low output power wireless applications. Analytical formulae are …

Rapid developments of energy harvesting in the past decade have significantly increased
the efficiency of devices in converting ambient free energy into usable electrical energy, thus …

Duty-cycling is commonly used to reduce power consumption at non-peak data rates.
Adaptive wireless networks may require very small duty-cycling ratios at very low data rates …

This paper describes a frequency-domain on-off keying (F-OOK) modulation method which
utilizes power detection of both a carrier and a sideband by modulating the carrier frequency …