Selective laser melting (SLM) is an emerging layer-wise additive manufacturing technique
that can generate complex components with high performance. Particulate-reinforced …

Laser powder bed fusion (LPBF) is one of the most widely used additive manufacturing
methods for fabricating metal components. It is possible to produce multi-material structures …

Al–12Si specimens are produced by selective laser melting (SLM) from gas atomized
powders. An extremely fine cellular structure is observed with residual free Si along the …

Highlights•Highly-dense Cu–10Sn bronze specimens fabricated by selective laser melting
(SLM).•Refined microstructure of SLM material compared to corresponding cast …

To enhance the toughness of metal matrix nanocomposites, we demonstrate a strategy that
involves the introduction of spatial arrays of nanoparticles. Specifically, we describe an …

Excellent mechanical and physical properties are usually mutually exclusive in W–Cu
composites, which makes it challenging to achieve outstanding comprehensive …

Iron, as the basic industry material was extensively studied in the past, but it could still offer
extended possibilities with the use of new processing techniques such as selective laser …

An in-depth study of the anisotropic mechanical behavior of Mg alloys is essential for
optimizing mechanical properties, designing high-performance Mg alloys, and developing …

The synergy of ultra-high strength and large ductility is a vital requirement in particular for
single-phase structural alloys; unfortunately these two properties are generally mutually …

The investigation found that the incorporation of MoS 2 particles as reinforcement in Al–4%
Mg material results in an increase in density and microhardness. The composite with 4% Mg …