The performance of CdTe solar cells can be very sensitive to the emitter/absorber interface,
especially for high-efficiency cells with high bulk lifetime. Performance losses from acceptor …

Abstract Antimony selenide (Sb2Se3) solar cells often demonstrate current–voltage (J–V)
distortion at low temperature, particularly at reverse bias or under red‐light irradiation. A …

Poor qualities of ZnMgO thin films are likely to be obtained at higher Mg content, which can
decrease the performance of ZnMgO-based devices. This study focuses on improving the …

A spike-like energy level alignment of Sb 2 Se 3 absorber with a Zn (O, S) buffer layer is one
of the crucial features for high efficiency solar cells based on Sb 2 Se 3/Zn (O, S) …

Cadmium Sulphide is the conventional n-type buffer layer used in thin film Cadmium
Telluride solar cells. It is well known that Cadmium Sulphide causes optical losses and …

Emerging photovoltaic (PV) technologies (eg, organic, perovskite, and solution processed
quantum dot) have attracted remarkable attention with the rapid growth of their efficiencies …

An initial structure was designed based on CuSbS 2 experimental data. Afterward, an
investigation on the performance of contact/CuSb (S 1-x, Se x) 2 alloy/buffer layer/i …

In this work, to improve the performance of three-stage co-evaporated Cu (In, Ga) Se 2
(CIGS) solar cells, a small amount of Ag was incorporated during the third stage, and the …

The purpose of the present paper is to focus on the impact of oxygen gas partial pressure
during the sputtering of i‐ZnO and ZnMgO on the transient behavior of Cu (In, Ga) Se2 …

In ultra-thin chalcopyrite solar cells and photovoltaic modules, efficient light management is
required to increase the photocurrent and to gain in conversion efficiency. In this work we …