Despite nuclear energy being a clean, sustainable source, its safety is a major concern,
especially after the Chernobyl and Fukushima accidents. Designing accident-tolerant fuel …

Among the additive manufacturing processes, selective laser melting has gained wide
popularity for manufacturing austenitic stainless steel (316L) due to the inherent advantages …

This article aims to numerically investigate the mechanical behaviour of concrete Brazilian
Disk (BD) samples when exposed to multi-level cyclic Brazilian loading. A numerical 3D …

Ratcheting deformation in association with bulk texture evolution in HSLA steel is studied in
this investigation. The cyclic deformation behaviors and damage modes of the specimens …

In this work, low cycle fatigue experiments under both strain and stress control modes with
different loading levels were conducted on 304 austenitic stainless steel at ambient …

The microstructure and texture of three 316L foils of 25 μm thickness, which were subjected
to different manufacturing process, were systematically characterized using advance …

The 316L stainless steel part built by laser powder bed fusion has attracted much attention
in recent years. However, current studies have not systematically revealed the influence of …

Abstract 316L stainless steel part built by laser powder bed fusion has attracted much
attention in recent years. However, current studies haven't systematically revealed the …

In this study, a method of repetitive high stress loading–unloading with small plastic
deformation is designed to simulate the extreme service conditions of a martensite stainless …

Hybrid printed circuit heat exchangers (H-PCHE) consisting of plate and fin bonded to a
microchannel heat-exchanger have been designed for generation IV nuclear power. This …