Oral defects lead to a series of function disorders, severely threatening the patients' health.
Although injectable hydrogels are widely studied in tissue regeneration, their mechanical …

Aluminum and its alloys are commonly used as lightweight materials in many industrial
sectors including aerospace but these materials exhibit poor adhesion properties, low …

This review describes the application of non-thermal plasma (NTP) technology for high
barrier layer fabrication in packaging area. NTP technology is considered to be the most …

Crumb waste tire rubber (WTR) was pretreated by oxygen low temperature plasma (LTP)
and modified by LTP polymerization process of ethanol monomer to improve the adhesion …

Human adipose derived stem cells (ADSCs) are being explored for the repair of craniofacial
defects due to their multi-differentiation potential and ease of isolation and expansion …

A conventional plasma grafting (PG) process for surface treatment has limitations; thus, it
should be modified to boost its efficiency. In this study, a new process called immersion–pad …

Vertical chemical gradients extending over a few nanometers were explored. The gradients
are based on plasma-polymerized oxygen-containing ethylene (ppOEt) films. Using plasma …

This work examines the growth dynamics of TiO 2-SiO 2 nanocomposite coatings in plane-to-
plane Dielectric Barrier Discharges (DBDs) at atmospheric pressure operated in a …

The exploitation of soft conducting polymer-based actuators suffers from two main
shortcomings: their short life cycle and the reproducibility of the fabrication techniques. The …

Surface chemical modification of cellulose-based substrates has been carried out by
atmospheric pressure plasma enhanced chemical vapor deposition (AP-PECVD) of acrylic …