The effects of cold rolling (CR) with different hot rolling (HR) reductions on the precipitation
behavior and mechanical properties of Al–Zn–Mg–Cu (AA7050) alloy are investigated by …

Aluminum alloy sheets with higher isotropy and finer grains possess larger post-formability
and better mechanical properties. However, it is extremely difficult to simultaneously realize …

In this study, the microstructural evolution and mechanical behavior of AISI 430 ferritic
stainless steel produced by cold single-roll drive rolling were investigated. By increasing the …

In the present study, high-strength and high-toughness Al–Zn–Mg–Cu/pure Al laminated
composite with a heterogeneous microstructure were manufactured by the compression …

In this work, the effect of cold rolling on microstructure, texture, and tensile properties of a Ni-
Fe-based superalloy for Generation Ⅳ nuclear reactor application was systematically …

The influence of asymmetric rolling on the microstructure, texture and mechanical properties
of Al–Mg–Si alloy was investigated comprehensively through finite element simulation …

Pure copper is very soft, however, hardening the pure copper with most strengthening
mechanisms leads to a significant reduction in electrical conductivity. Grain refinement is a …

In this study, AA7075 sheets were processed by cryorolling and room-temperature rolling
respectively, and subsequent aging. The microstructure evolution and mechanical …

In this research, 90% asymmetric unidirectional rolling and post‐annealing are applied to
electrolytic tough‐pitch (ETP) copper. The effect of low‐temperature (200° C) annealing on …

The aging precipitated phases are of great significance for the strengthening and
toughening of Al–Zn–Mg alloys. In this work, pre-precipitating was realized through equal …