In-situ mechanical testing in a scanning electron microscope (SEM) equipped with an
electron backscatter diffraction (EBSD) system has quickly gained popularity, particularly …

In situ tensile tests, accompanied by scanning electron microscopy coupled with electron
backscatter diffraction (EBSD) analyses were performed on neutron-irradiated 304L steel …

In recent publications, we have shown that repeated bending and unbending during tension
can significantly increase the percent elongation-to-fracture (ETF) of metallic sheets. A …

The stress relaxation test is a commonly used transient test to determine the deformation
kinetics during plastic deformation. This study reports the time-dependent deformation …

This paper describes the main results from an experimental investigation into the
consequence of cyclic bending under tension on elongation-to-fracture (ETF) and strength of …

This paper describes results acquired in an investigation into determining the influence of
cyclic-bending-under-tension (CBT) and annealing on improving elongation-to-fracture …

The fatigue behavior of a directionally solidified (DS) Ni-based superalloy was investigated
under in-phase (IP) and out-of-phase (OP) thermomechanical fatigue (TMF) conditions …

Servo press forming machines are advanced forming systems that are capable of imparting
interrupted punch motion, resulting in enhanced room temperature formability. The exact …

Industrial servo presses have been used to successfully demonstrate improved formability
when deforming sheet metals. While the time dependent viscoplastic behavior of material is …

The application of interrupted die motion during the deformation process in a servo press
cycle is known to enhance the forming limit of metallic materials. This observation is …