CiNii 博士論文 - Effect of simulated pulpal pressure on all-in-one adhesive bond strengths to
dentine CiNii 国立情報学研究所 学術情報ナビゲータ[サイニィ] 論文・データをさがす 大学 …

OBJECTIVES: To evaluate the durability of all-in-one adhesive systems bonded to dentine
with and without simulated hydrostatic pulpal pressure (PP). METHODS: Flat dentine …

Materials and Methods: Forty intact maxillary premolars were distributed into four groups
(Group 1–3M ESPE Adper Single Bond 2 total etch adhesive, Group 2–3M ESPE Single …

Purpose To measure the in vitro dentin microtensile bond strength of established adhesives
under different hydrostatic pulpal pressures. Methods After IRB approval, 24 human …

During polymerization of resin composites, shrinkage stresses compete with resin-dentin
bonds in a manner that can cause failure of the bond, depending upon the configuration of …

Purpose: To evaluate the effect of three different liquids used for intrapulpal pressure (IPP)
simulation on the microtensile bond strength (µTBS) of three adhesive systems to dentin …

Purpose: To evaluate the influence of the method and duration of storage for different types
of teeth prior in their use in dentin bonding tests with three adhesive systems. Materials and …

The purpose of this in vitro study was to measure and compare the in vitro micro shear bond
strengths of the following dentin bonding systems to different dentin surfaces under …

This in vitro study evaluated the shear bond strengths of five adhesive systems bonded to
dentin with and without simulated physiologic hydrostatic pressure. To simulate pulpal …

Objective: This study evaluated the dentin adhesion of a universal adhesive (Single Bond
Universal; SBU) applied in either etch-and-rinse (E&R) or self-etch (SE) mode in the …